{"id":"CVE-2026-79982","state":"PUBLISHED","title":"Out-of-bounds write in the USB Bluetooth HCI transport class when a controller-to-host HCI packet exceeds the bulk endpoint maximum packet size","description":"The Bluetooth HCI USB transport class of the new USB device stack, subsys/usb/device_next/class/bt_hci.c, copies every controller-to-host HCI packet into a USB transfer buffer before enqueuing it on an endpoint. bt_hci_tx_sync_in() allocated that buffer from bt_hci_ep_pool, a fixed pool whose slots are only USBD_MAX_BULK_MPS bytes (64 on full-speed-only builds), and then performed net_buf_add_mem(buf, bt_buf->data, bt_buf->len) with no length check. HCI event and ACL buffers are sized by CONFIG_BT_BUF_EVT_RX_SIZE and CONFIG_BT_BUF_ACL_RX_SIZE and can be far larger, so the copy runs past the end of the 64-byte slot into the adjacent slots and into whatever follows the statically allocated pool.\n\nThe device runs the local Bluetooth controller in raw HCI mode (CONFIG_BT_HCI_RAW), so the oversized packets originate over the air. With the HCI buffer sizes recommended for full-featured controllers, an unauthenticated attacker within Bluetooth range can supply the overflowing bytes: a connected peer that negotiates Data Length Extension can send ACL fragments up to CONFIG_BT_CTLR_DATA_LENGTH_MAX bytes, and an attacker that merely broadcasts extended advertising data reaches the same path through LE Extended Advertising Report events, which the controller fragments only to CONFIG_BT_BUF_EVT_RX_SIZE. In the stock configuration the overflow is already reached without any radio traffic: the mandatory Read Supported Commands command-complete event is 70 bytes and overruns the 64-byte slot by six bytes on every host initialization.\n\nBecause net_buf_add_mem() validates tailroom only through an assertion unless CONFIG_NET_BUF_HARDENING is enabled, builds with CONFIG_ASSERT=n — the usual production setting — silently corrupt memory adjacent to the USB buffer pool with attacker-chosen contents, which on a target without memory protection between subsystems can lead to arbitrary code execution. Builds with assertions enabled fail the assertion instead and panic, giving a remotely triggerable denial of service. The fix introduces a separate bt_hci_tx_pool sized to MAX(BT_BUF_ACL_RX_SIZE, BT_BUF_EVT_RX_SIZE) for the controller-to-host direction while leaving the host-to-device pool at the endpoint packet size, which is already bounds-checked during reassembly.","publishedAt":"2026-10-23T19:56:19.432Z","updatedAt":"2026-10-23T19:56:19.432Z","severity":{"score":8.8,"label":"High","version":"3.1","vector":"CVSS:3.1/AV:A/AC:L/PR:N/UI:N/S:U/C:H/I:H/A:H","source":"zephyr"},"assigner":"zephyr","products":["zephyrproject zephyr"],"affected":[{"vendor":"zephyrproject","product":"zephyr","packageName":"zephyr","defaultStatus":"unaffected","versions":[{"version":"3.3.0","status":"affected","lessThanOrEqual":"4.4.2","versionType":"semver"}],"collectionURL":"https://github.com/zephyrproject-rtos/zephyr","programFiles":["subsys/usb/device_next/class/bt_hci.c"],"programRoutines":[{"name":"bt_hci_tx_sync_in"}]}],"references":["https://github.com/zephyrproject-rtos/zephyr/commit/0419defd2391652edc27689d206fcd9c48439d4a","https://github.com/zephyrproject-rtos/zephyr/security/advisories/GHSA-w5px-w97v-c3hj"],"weaknesses":["CWE-787"],"ingestedAt":"2026-10-29T20:13:07.220Z","source":{"repository":"CVEProject/cvelistV5","path":"cves/2026/79xxx/CVE-2026-79982.json","commit":"556c9d3a8cd17e218bb8e452ba7cd619a384ff47"},"raw":{"dataType":"CVE_RECORD","dataVersion":"5.2","cveMetadata":{"cveId":"CVE-2026-79982","state":"PUBLISHED","datePublished":"2026-10-23T19:56:19.432Z","dateUpdated":"2026-10-23T19:56:19.432Z","assignerShortName":"zephyr","assignerOrgId":"e2e69745-5e70-4e92-8431-deb5529a81ad","dateReserved":"2026-08-25T16:06:38.229Z"},"containers":{"cna":{"title":"Out-of-bounds write in the USB Bluetooth HCI transport class when a controller-to-host HCI packet exceeds the bulk endpoint maximum packet size","descriptions":[{"lang":"en","value":"The Bluetooth HCI USB transport class of the new USB device stack, subsys/usb/device_next/class/bt_hci.c, copies every controller-to-host HCI packet into a USB transfer buffer before enqueuing it on an endpoint. bt_hci_tx_sync_in() allocated that buffer from bt_hci_ep_pool, a fixed pool whose slots are only USBD_MAX_BULK_MPS bytes (64 on full-speed-only builds), and then performed net_buf_add_mem(buf, bt_buf->data, bt_buf->len) with no length check. HCI event and ACL buffers are sized by CONFIG_BT_BUF_EVT_RX_SIZE and CONFIG_BT_BUF_ACL_RX_SIZE and can be far larger, so the copy runs past the end of the 64-byte slot into the adjacent slots and into whatever follows the statically allocated pool.\n\nThe device runs the local Bluetooth controller in raw HCI mode (CONFIG_BT_HCI_RAW), so the oversized packets originate over the air. With the HCI buffer sizes recommended for full-featured controllers, an unauthenticated attacker within Bluetooth range can supply the overflowing bytes: a connected peer that negotiates Data Length Extension can send ACL fragments up to CONFIG_BT_CTLR_DATA_LENGTH_MAX bytes, and an attacker that merely broadcasts extended advertising data reaches the same path through LE Extended Advertising Report events, which the controller fragments only to CONFIG_BT_BUF_EVT_RX_SIZE. In the stock configuration the overflow is already reached without any radio traffic: the mandatory Read Supported Commands command-complete event is 70 bytes and overruns the 64-byte slot by six bytes on every host initialization.\n\nBecause net_buf_add_mem() validates tailroom only through an assertion unless CONFIG_NET_BUF_HARDENING is enabled, builds with CONFIG_ASSERT=n — the usual production setting — silently corrupt memory adjacent to the USB buffer pool with attacker-chosen contents, which on a target without memory protection between subsystems can lead to arbitrary code execution. Builds with assertions enabled fail the assertion instead and panic, giving a remotely triggerable denial of service. The fix introduces a separate bt_hci_tx_pool sized to MAX(BT_BUF_ACL_RX_SIZE, BT_BUF_EVT_RX_SIZE) for the controller-to-host direction while leaving the host-to-device pool at the endpoint packet size, which is already bounds-checked during reassembly."}],"affected":[{"vendor":"zephyrproject","product":"zephyr","packageName":"zephyr","defaultStatus":"unaffected","versions":[{"version":"3.3.0","status":"affected","lessThanOrEqual":"4.4.2","versionType":"semver"}],"collectionURL":"https://github.com/zephyrproject-rtos/zephyr","programFiles":["subsys/usb/device_next/class/bt_hci.c"],"programRoutines":[{"name":"bt_hci_tx_sync_in"}]}],"references":[{"url":"https://github.com/zephyrproject-rtos/zephyr/commit/0419defd2391652edc27689d206fcd9c48439d4a","name":"Fix commit","tags":["patch"]},{"url":"https://github.com/zephyrproject-rtos/zephyr/security/advisories/GHSA-w5px-w97v-c3hj","name":"GHSA-w5px-w97v-c3hj"}],"metrics":[{"format":"CVSS","cvssV3_1":{"version":"3.1","vectorString":"CVSS:3.1/AV:A/AC:L/PR:N/UI:N/S:U/C:H/I:H/A:H","baseScore":8.8,"baseSeverity":"HIGH"}}],"problemTypes":[{"descriptions":[{"cweId":"CWE-787","lang":"en","description":"bounds","type":"CWE"}]}],"providerMetadata":{"shortName":"zephyr","orgId":"e2e69745-5e70-4e92-8431-deb5529a81ad","dateUpdated":"2026-10-23T19:56:19.432Z"},"x_generator":{"engine":"cvelib 1.8.0"}}}}}